Run for your life

There are many way to clear CMOS, by reset a jumper or release batteray for 20-30 minutes. Here is another way to clear CMOS by debug program from computerhope.
Boot from startup disk. Then type debug [Enter] and if you get “-”, type code below :
A <ENTER>
MOV AX,0 <ENTER>
MOV AX,CX <ENTER>
OUT 70,AL <ENTER>
MOV AX,0 <ENTER>
OUT 71,AL <ENTER>
INC CX <ENTER>
CMP CX,100 <ENTER>
JB 103 <ENTER>
INT 20 <ENTER>
<ENTER>
G <ENTER>
Q <ENTER>
Reboot the PC’s and you will get Setup to correct all incorrect values again.

No related posts.

This entry was posted on Wednesday, October 22nd, 2008 at 10:24 am and is filed under Computer, Tips & Trick.You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.